About this 3D model

? Welcome to GlennovitS3D. Join the Club on Printables.com to support creation of new models , get access to exclusive models , and get commercial rights, to sell prints of my models. Join today - GlennovitS3D - or check out my model collection ?️ Treasures come in many sizes and variations - and this one is flat-packed ! Enjoy the assembly of a small treasure chest - or give it as a gift for pirate-movie-fans. It is all printed - nothing else is needed - just print 1 card and go! Overview It comes in different versions for you to print: 1 color (the fastest to print!) 2 colors (for details to show more clearly - my favorite) Assembly Assembly requires multiple steps. Here is my prefered order: Cut out all elements from the card Press a box back into one of the box ends Press the bottom into the box end Press the box front into the box end Press the other box end onto the 3 pieces Celebrate that the bottom part is done ? Bend the lid top to a curve that matches the lid ends Tip : Be sure to bend all sections to get as smooth a lid as possible - take one small section at a time. Press the lid top into a lid end Tip : There are 5 small tabs to insert - be careful not to break them. I insert the top tab first, and then continue with the lower tabs until everything is fitted - before pressing into hard! Press the other lid end on the lid top as above Celebrate that you completed the treasure chest by putting the lid on the chest! ? If any of the items is a little too loose, maybe some glue could help. If anything is too tight, maybe sand/scrape the edges instead of pressing too hard at first. Print instructions Here is a few suggestions: Speed : Low 1. layer speed (maybe below 50% of normal - just the first layer to ensure bed adhession with all the small lines) Orientation : The cards should be oriented correctly Brim : No. Would take a long time to clean the model.. Happy printing!