About this 3D model

Hexagonal 18650 portable charger Parts Needed: Wire Solder Nickel strips for making battery packs 1x 18650 battery 1x Charge module (paste the next bullet point into amazon and pick the one that looks like the last photo) “Onyehn 5v boost step up power supply module lithium battery charge protection board for diy charger" Tools Needed: Spot welder Soldering iron Assembly Instructions: Spot weld a nickel strip to each end of the 18650 Solder wires to the strips at each end of the 18650(don't use too much solder or it wont sit flat) Trim the excess and fold the strips over the ends of the battery as flat as possible Look at where the charger module will sit when everything is seated and trim the excess wire Strip and solder the wires to the charger module(don't mess up the polarity) Bend the wires and glue everything in place with some CA or hot glue Admire your hard work sweatshop slave