About this 3D model

The photo size is 200*167mm. A total of 6 colors of PLA filaments are used, namely: Black, Green, Blue, White, Orange, and Yellow. Attention!!! 0.08 layer height slicing takes a long time! Starting layer height 0.16, printing layer height 0.08 Printing method (with only one AMS): 1. Load the Black, Green, Blue, and White PLA filaments into the AMS from slot 1 in order. 2. Set the AMS color in the printer's software to Black, Green, Blue, and White. 3. When the printing switches to Blue and White, you can open the AMS, take out the Black and Green filaments, and replace them with Orange and Yellow in order (it is recommended to pause printing at the last layer of White to avoid forgetting to manually switch filaments. After switching filaments, you can continue printing). (There was a 3mf file for printing originally, but it was not uploaded to the website because the slicing time was too long, so everyone can only set it up themselves). The first layer uses Black The fourth layer (0.4mm) switches to Green The fifth layer (0.48mm) switches to Blue (It is recommended to add a pause at the 11th layer to avoid forgetting to change filaments) The 12th layer (1.04mm) switches to White The 16th layer (1.36mm) switches to Black The 20th layer (1.68mm) switches to Green The original description for changing filaments is as follows: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA Kexcelled Black Transmission Distance: 0.2 PLA Kexcelled Green Transmission Distance: 3 PLA Kexcelled Blue Transmission Distance: 3 PLA Kexcelled White Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 10 PLA Kexcelled Yellow Transmission Distance: 6.8 Swap Instructions: Start with Black At layer #4 (0.4mm) swap to Green At layer #5 (0.48mm) swap to Blue At layer #12 (1.04mm) swap to White At layer #16 (1.36mm) swap to Orange At layer #20 (1.68mm) swap to Yellow for the rest.