About this 3D model

I really love the Dinzl Assortment Boxes by Dinzl Ordnungstechnik and i also love Gridfinity for organizing small parts. When i looked a both, if figured that they are an almost perfect match for 8x5x6u Gridfinity bins. They are made under different names for quite a while now but the design changed from those made 20+ years ago - especially the hinges and the joints at the corners are slighty different. You can get them used of ebay for cheap or buy them brand new online here: https://www.awela-shop.de/idealo/sortimentskoffer/181/dinzl-sortimentskoffer-s50 Compatibility / Printing The inserts are currently compatible with all boxes with 340 x 240 x 50 mm . Figure out wich Version/Model you have (see images below if you unsure) if you have one of the following, print the “ new ” Version Sortimentskoffer S50 Sortimentskoffer SN50 Sortimentskoffer SE50 Sortimentskasten DIMA 77/1 else the “ legacy ” insert is right for you, since it has a bit of tolerance and also cutouts at the corners, to overcome damaged corners Everything prints with no supports. PLA with 2 walls and 10 to 15 % Infill is plenty strong. Print 2 pieces as is - they have a rotational symmetry (do not mirror them) “ new ”: overlapped corner is inset slightly sharp corner with relieve hole hinge mounted on the outside “legacy”: corner directly overlaps corner is drawn inwards hinge is mounted on the inside Assembly Put the 2 pieces together outside the box (no glue needed) and gently slide them in - on the legacy version, the hinge is on the inside, so you need to slightly bend and wiggle it in If your box does not come with a foam on the top, glue some 3 to 4 mm soft foam on top of the lid to prevent small parts falling out the bins when the box is turned upside down