About this 3D model

Bambu 4-in-1 PTFE Adapter Bracket This is a small bracket to hold the Bambu 4-in-1 PTFE Adapter for the Bambu Lab X1 Carbon and P1S. This bracket has a nice fit with the PTFE adapter, providing a perfect angle for the PTFE tubes in and out to the printer. The PTFE adapter I used is this one from the Bambu Labs store: https://store.bambulab.com/products/bambu-4-in-1-ptfe-adapter I have a similar bracket which holds the adapter if you are using my side spool holder found here on Maker World: https://makerworld.com/en/models/169803 You will need the following to mount the adapter: 1 - M3 x 16mm screw 2 - M3 x [10mm or 12mm] screw This is designed to print without any supports. If you have an AMS, I have included to objects in the model so you can assign a different colour to the logo if you would like to. Print Settings: Layer Height: 0.2 mm Wall Loops: 2 Shell Layers: 3 No brim, or supports required. A sacrificial layer is used where the two holes are - use an awl or screwdriver to poke through them. Membership Get a commercial license here! Instructions: 1. Remove the PTFE adapter on the back of the unit. 2. Unscrew the existing M3 screw on the top right of the back of the printer - unscrew the left screw, leaving the right screw in place. 3. Use an awl or a screwdriver to punch through the sacrificial layer used in each of the two holes. 4. Use an M3 x 16mm screw to attach the splitter adapter bracket to the printer. 5. Use either an M3 x 10mm or a M3 x 12mm screw to attach the splitter adapter onto the bracket.