About this 3D model

This box, weighing 75g in total, measures 142*117*70mm. It has an asymmetrical division into two sections, allowing it to comfortably store most card games and tokens (I have placed the hexagonal tiles of Catan in it). The lid is magnetic and utilizes eight 6mm diameter, 3mm thick common neodymium magnets. I believe many of you have hundreds of these! They're also inexpensive! The overall box is thin, and all the lids can be deformed and opened from any direction. Pay attention to the direction of the magnets when installing them. The magnet installation position has been designed with compression space to prevent the side from cracking after magnet installation. I used an a1mini, and the box and lid took 2.5 hours to print. 1. Pay attention to the magnetic pole installation direction shown in the picture below!!! 2. Place two magnets simultaneously. First, press the lid magnets in, facing the floor. Note that the magnets on the lid cannot be fully pressed into the slots; they should be slightly protruding!!! 3. Keep the two magnets as shown in the picture below, and then align them with the box and press them in.