About this 3D model

Summary I just edited it so a 2 Euro Cent coin could fit I haven't yet printed it but I will and put up a picture There are these little teeth there that should help hold the coin Although they are just there because I was too lazy to remove them Use the "Drunk Domo Key Chain 2EUROCENT_2" Version It's the one with the higher quality and the actual size Print Settings Printer Brand: Creality Printer: CR-10S Rafts: No Supports: No Resolution: 0.2 Infill: 15 Filament: Geetech PLA white Notes: It's a pretty easy print the only problem that could occure is the bridgeing on the upper half of the coin-slot did not test it yet, but will.