About this 3D model

I used Orcaslicer's pre-built Hueforge settings that can easily be put into Bambu Studio , or try Orcaslicer . Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA BambuLab Matte Charcoal Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Matte Dark Red Transmission Distance: 1.5 PLA BambuLab Basic Jade White Transmission Distance: 5 PLA BambuLab Matte Ice Blue Transmission Distance: 3.5 Swap Instructions: Start with Charcoal At layer #9 (0.8mm), swap to Blue Gray At layer #12 (1.04mm), swap to Dark Red At layer #18 (1.52mm), swap to Jade White At layer #22 (1.84mm), switch to Ice Blue for the rest. I added a pause just to swap AMS slot 1 for the 5th color.