About this 3D model

Summary This is a powerbank holder for the IKEA SKÅDIS Pegboard. It takes up two holes on the pegboard. It can also be used to store other things if you want. Parametric The model is parametric, so you can input the dimensions of your powerbank and it will adjust the dimensions of the model accordingly. It has built-in gaps in the width and depth of 1.6 mm, so input the REAL SIZE of your powerbank, unless: You want a lot of wiggle-room like in the example in the pictures. Then, you would want to increase the width and depth. Or You want ALMOST no wiggle-room but still a little bit. Then, you would want to subtract 1.2 mm from the powerbank width and depth. Or You want a extra-tight fit where the powerbank can't move at all. Then, you would want to subtract 1.6 mm from the width and depth. BUT BEWARE that you may have such a tight fit that the powerbank can't fit and you need to file the edges of the hole. NOTE: The ABSOLUTE MINIMUM height of a powerbank for the parametric model to work is 95 mm, so if your powerbank has a height between 55-95 mm, then set it to 95 mm. The powerbank will still fit but more of it will just be covered by the holder. Old version The old version is designed for the RELOAD 20 powerbank by SKROSS but fits any powerbank up to the dimensions of 64 mm width x 23 mm depth x any height (recommended 130+ mm)