About this 3D model

Print with a brim. * added a wing to the model to help with turning * *added a zip tie slot * *works with the s1 pro but can’t be screw down. this was verified by another user * This should fix the issue with the heated bed wires from flexing over and rubbing on the motor. Installation notes. 1-remove the screw right under the bed wire that s fastening the bottom cover. 2-pull the bed all the way to the front . 3-install the support bracket. please leave ⭐ review and rate. Buy me a some raman if i helped you out in anyway. https://ko-fi.com/3deeznutz Check out my other designs. https://cults3d.com/en/users/3DeezNutZ/3d-models https://www.printables.com/@3DeezNutz_752861/models