About this 3D model

3d miniature of Magic Kingdom in Walt Disney World, Florida! Also includes the Contemporary Resort and Bay Lake Tower! Epcot Miniature: https://makerworld.com/en/models/1252286-epcot-disney-world-3d-miniature-multicolor Disneyland California Miniature : https://makerworld.com/en/models/252986#profileId-269372 Check out my collection of other miniatures: https://makerworld.com/en/u/1935755220/collections/146964 Model created in Blender using data imported with the Blosm addon. Slicing & Printing Details This model was designed to be printed with a 0.4mm nozzle ( 0.16mm layer heights ) or a 0.2mm nozzle ( 0.08mm layer heights ) I have uploaded two different print profiles for each nozzle size with the recommended settings pre-applied ready to slice and print! Each print profile includes two different models of Magic Kingdom, one with suspended monorail tracks and another with grounded tracks (no overhangs). Suspended Monorail Tracks Grounded Monorail Tracks If printing with a 0.4mm nozzle , I highly recommend slicing the model using ‘Classic’ wall generation . ‘Arachne’ walls will usually omit some of the monorail pillars leading to poor bridging and stringing. *Note: if smaller details disappear after slicing with ‘Classic’ wall generation, try lowering the line/extrusion width of outer walls (external perimeters) closer to 0.4mm. Can also try enabling “ Detect Thin Walls ”! If printing with a 0.2mm nozzle ( or 0.4mm nozzle with the grounded tracks ), I recommend slicing the model with ‘Arachne’ wall generation to include buildings and smaller details ‘Classic’ walls often fails to include. The included designer print profiles have the above settings pre-applied! Filaments used in photos: Sunlu Matte White (miniature), Bambu Matte Black (frame), Sunlu Sky Blue (water) Framing Details This model measures almost exactly 6.7in by 4.7in (170.5mm X 119.5mm) and should fit most 5x7 frames (assuming frame lip/overlap is around a quarter inch). Feel free to change the scale/size of the model(s) to meet your needs. Personally I use these cheap frames from Amazon: https://www.amazon.com/dp/B0C8HY7YSQ And blue printer paper: https://www.amazon.com/dp/B00006IDQT I also included a fully printable frame (including a 1mm thick water plate) designed to fit all my miniature cities. Gif of the Printable Frame A frame is not required! This model looks great by itself and can be displayed almost anywhere. Membership Subscribe for a Commercial License to sell physical prints of my models! License stays valid as long as the subscription is active.