About this 3D model

I wanted a tiny cable tie anchor and could only find 1" ones here and people were suggesting to scale it for 0.75" adhesive tape, but it also scaled the hole for the cable tie making it unusable. Three files, all the same height, all allow 4mm cable ties Small: 0.5" pad Med: 0.75" pad Large: 1" pad No support needed, bridges print fine on Prusa. See below for Bambu settings to bridge better. I think concentric Top Layer makes for a good look. If using Bambu: (I tested this before the 1.6.2.4 update which was supposed to fix Archane issues with bridges) - Slow down Speed: Bridge: 20 - Increase Strength: Advanced: Infill/Wall overlap: 60% Amazon Cable Ties: https://a.co/d/27Hqk2p