About this 3D model

Landmark: The end of the rainbow This is a Screwtop Pot of Gold that can be filled with anything you feel is at the end of the rainbow - perhaps you will even find a leprechaun or even an Emerald Dragon! The Full Emerald Dragon at 100% fits inside the Pot of Gold at 100%. The Half Emerald Dragon fills the pot halfway, leaving room for plenty of other goodies or printer waste! NOTES: For higher detail on the Emerald Dragon lower the layer height. The coins on the lid also look better at a lower layer height. For a better looking pot of gold, slow the outer layer, and add supports to the bottom of the pot ending at the same height as the feet - there is some rippling at these overhangs for me. The bulge of the pot obscures this for the most part unless the pot is flipped over. Here is a picture of the supports and 2-3 vertical line supports makes a world of difference for better looking bottom overhangs. 3MF pot files already have the supports painted on and a slowed outer wall for a nice looking pot. All 3 files can be printed without supports if preferred. I also suggest printing with seams at the back of the pot or Bambustudio will try to put it through the shamrocks. Do not over tighten the coin top lid onto the pot or you might have problems getting it open later; a few light spins closed is all it need to be secure. This File is Private use ONLY: If you would like to print copies for physical use please download it HERE . Buy it once and sell physical copies forever. There is also a bundle with my Lucky Shamrock Dragon HERE . All my St. Patrick's Day Commercial files are 25% off using GREEN2024 until March 18th!