About this 3D model

A simple solder fume extractor/exhaust fan on your desktop, comes with an adjustable angle stand. A chamber is reserved on the bottom to store extra power cords and connectors, and s self-locking cable clamp for securing the power cord. You will need: 1 x 8015 Fan, thinner or thicker fans work equally well, but you may need to adjust the size of the screws below. 8 x M3 x 16 Screws, countersunk head screws recommended. 2 x M3 x 8 Screws. 2 x M3 brass insert. 1 x 70mm cylindrical HEPA filter, the height should be between 24-30 mm Connector, switch, regulator, remote controllers, etc. Assembling: 1 Insert the brass insert into the holes on the side. 2 Using 4 x M3 x16 screws to secure the fan. 3 Wire and hide the switch, regulator, and extra wires in the bottom chamber. 4 Pass the power cord through the hole on the back and secure it with the cord clamp. 5 Using 2 x M3 x 16 screws to fix front cap. 6 Using 2 x M3 x 8 screws to fix stand. 7 Installing the HEPA Filter and secure with back cap and 2 x M3 x 16. Print Guide: Print with PETG or ABS, PLA is fine if you're sure you don't want to use it in a hot environment. The screw holes have been pre-threaded except for the stand mounting screw holes on the side.