About this 3D model

Magnetic Fidget Slider Uses total of 12 6x3mm magnets, 6 for each side. I recommend N52 magnets for a stronger snap. Printing: 0.2mm layer height for the housing 0.1mm layer heigt for the top plate for better quality, otherwise 0.2mm as well no supports needed Assembly: Glue the magnets to the housing, then glue the top plate on. Repeat for other half of the slider, minding the magnets polarity. Bigger Version here : Magnetic Fidget Slider - Bigger Version My other Fidget toy MFT - Magnetic Fidget Toy (6x3mm magnets)