About this 3D model

Boost Me If you like this model please boost me - it doesn't cost you anything! Thank you! As I found the standing clip of the Belkin BoostCharge Pro Magsafe puck a little awkward and hard to fold out without a tool I designed this charging stand. It consists of 2 parts only that are connected after the charging puck cable has been inserted into the top part. The puck is then squeezed into the top part - there is a gap between the rear side of the puck and the top holder part so you can add some blue tac to fix the charging puck (this is not a design flaw, the gap is intentional) The top part has a hole on the back so the puck can be squeezed out from the back side, again. The puck cable is inserted through the top of the upper part and slid through the hollow core of the upper part, and then goes through the core of the bottom part to finally come out at the rear of the bottom part. --------------------------------- Changes of Version 2: Improved dimensions of top part Improved dimensions of bottom part Much tighter fit of the 2 connected parts --------------------------------- Note: The charging puck comes with a rubber cable strap which you need to remove for the cable to fit through the channel of this puck holder The charging puck protrudes out of the top part ca. 0.5mm, as the puck needs to sit flush against the back of your mobile phone Also refer to my other version of this model which also accommodates for an Apple watch! Have fun printing this model!