About this 3D model

Introducing an original kinetic water wheel sculpture awaiting its debut in the world of 3D printing. If you're up for the challenge, feel free to give it a try, and don't forget to share your experience! Originally conceptualized with a single motor in mind, this design boasts sufficient symmetry to potentially accommodate two motors, offering versatility and enhanced performance. Parts to Print: Leg x2 Leg Base x2: (Optional but recommended for a more permanent setup) Axle Female x1 Axle Male x1 Bucket x16 Clip x1: (Or x2 if opting for dual motors) Small Gear x1: (Or x2 for dual motors) Pin x2 Wheel x2: (The largest part, measuring approximately 184.776 mm in width. If you can print this, you can print the rest!) Additional Parts Required: To motorize the sculpture, you'll need a geared DC motor. The design is compatible with the "12mm Micro DC Gear Motor – 34mm Type Model NFP-1812-N20". While the sculpture accommodates two motors, one may suffice for operation: Two skateboard bearings (16 mm outer diameter; 5 mm inner diameter; 5 mm width): Assembly Instructions: The buckets are designed to be affixed using cut printing filament (~2 mm diameter) functioning as axles between the two main wheels. Triangular pins are included to prevent the main wheels from sliding along the axle. The axle comprises two parts that can be screwed together, simplifying the printing process (in theory). (Note: While the sculpture lacks functionality in terms of water flow, serving as a prototype, it showcases intricate design and craftsmanship. Future iterations may explore incorporating functional elements such as water channels or mechanisms for water discharge.)