About this 3D model

Purge Line Bin for Bambu Lab P1P + P1S (front fit) Purge Lines? Into the bin ? A small, flat waste container for Purge Lines and the usual mini-print waste – directly in front of the Bambu Lab P1P/P1S The part is simply pushed onto the front and secured by the small extension at the back under the printer (fits the height of the "factory feet"). Meaning: it stays where it should – and doesn't fly across the PrintLab with the first draft. ? Features Front-Fit & lockable under the printer (P1P & P1S tested) Dimensions (visible area): 240 × 100 × 15 mm Inner radii for easier removal of Purge Lines Embossed front lettering as a small gimmick: “PURGE LINE BIN” 2 variants: Single color and AMS Variants ) Standard (Single Color) Simply print and use. Optionally, you can also print the top edge in two colors without AMS using a filament change pause (see tip below). AMS Version (2-Color) For everyone with AMS: embossed text + top edge are printed in a second color. Looks smart, remains functional, and simply makes the bin a little “Premium”. ? In the slicer, you can easily color the top edge to your liking using “Color - Height Range”, for example. Color Tip without AMS (manual color change) If you don't have an AMS but want to print the top edge in two colors: Set a pause on the layer in the slicer where the colored edge should begin Layer 71 (0.2 mm) is a good starting point – this can of course vary depending on the layer height Have fun printing & less purge chaos in front of the printer! ? And if you leave a Like , a Comment , or a Make : I would be very happy about it… Print Settings (recommended) 0.2 mm Layer height 3 Walls (optional 4, if you want "Overkill League") 15% Infill (Gyroid or Grid – both fit well here) No supports Filament: PLA is absolutely sufficient