About this 3D model

Remix of the chip cliv V3 by @dav88 to add a hole for a 2x6mm magnet! Its just a tad larger than the original to support the magnet. I designed the hole with a 0.2mm tolerance and was able to pressure fit the magnet in the hole without gluing, if you have better tolerances than I you may need to use a small dab of superglue. Print Settings Printer Brand: LulzBot Printer: TAZ 6 Rafts: No Supports: No Resolution: 0.25 Infill: 15% Notes: Pretty much any settings will do, no supports. Category: Household