About this 3D model

A full color lithophane art based on a fan art of Bocchi the Rock! (孤独摇滚! ぼっち・ざ・ろっく！). You must have the CMYW colored filaments put in the AMS in this exact order (Cyan-Magenta-Yellow-White). My color is tuned based on eSun or Bambu filaments, so your color may vary by a little. Recommended at least 0.4mm nozzle or finer. 0.6mm would not give good results as I tested. If the lines of your print turned out not sharp, consider lowering your extrusion rate by a little, because the lithophane is quite a “dense” print with lines stacked together. Sometimes they overflow and ooze out. The edges (rectangular area beyond colored “cloud” region) can be cut off with scissors or razor blade. The original artwork is by @Nyancul at Pixiv and you can find the original post here .