About this 3D model

Sometimes we need something simple. It's a small kitchen composter. We were fed up with the small trash can placed on the ground where we throw our organic waste so that it ends up in the compost in the garden. So here I made a wall support for a compost “basin”. I chose to make a basin shape for two reasons: 1 You can't put it just anywhere. If we take it, it is to empty it, and put it back in its place, on its support. Then, it is also because a square trash can would have been more complex to clean inside, especially in the corners, where organic waste can leave unwanted things. Simply add a 1.75mm PLA or ABS filament (standard...) that you slide into the holes to mount the hinge once everything is printed. Cut a piece a little longer (25cm), once in place, cut at the edge to leave 1 or 2mm overhang, and burn with a lighter to lock everything in place. 2 screws to install it against a wall and everything is ok!