About this 3D model

This is a Miniature house to use as a light source lantern. in the photos i used battery powered flickering candle light, but you can use any small battery operated light Do Not use real candles *what you need to print:2 x side glass.1 x front glass.1 x top glass.1 x bottom plate.1 x back plate.1 x roof.1 x front wall.1 x right wall.1 x left wall. *Assembly:- use 4 pieces of M3x6mm to fasten the top holes of the walls.- use 4 pieces of M3x8mm to fasten the bottom plates with the walls.- use any clear crafting glue to stick the glass to the walls (just few little drops will do the job, do not over flow the glue.- start fastening the back plate to the side walls then the connect the bottom plate to the walls.- Roof does not need glue nor screws, i made it so it can sit on its place for you to open to put and remove the light. hope you enjoy my design, and i appreciate your support, to encourage me to create more unique designs.