About this 3D model

This was my prompt that generated this image with tensor.art Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA Sunlu Matte Black PLA Sunlu Matte Dark Grey PLA Elegoo Matte Grey PLA Jayo Grey (not so dark as Sunlu) PLA Eryone Matte HS light grey PLA Eryone Matte HS White Swap Instructions: Start with Matte Black At layer #7 swap to Dark Grey At layer #9 swap to “not so dark” Grey At layer #12 swap to Grey At layer #15 swap to Light Grey At layer #19 swap to Cold White for the rest. Use the .3mf file for exactly these filaments but change to what you've got in the slicer. For any other settings I used my thanks go to @Don Mantis because I used the same settings as for his art.