About this 3D model

Small Textured Vase I have set the layer height to 0.08mm to reduce the seam line visibility, which should not be a problem with vase mode but for some reason it shows up, I believe it is a bug in Bambu Studio / Prusa Slicer / Orca Slicer. Although hard to see in the image below the seam is quite visible irl. 0.2mm Layer Height, Visible Seam The vase is 99mm tall, it can be scaled up but will take a very long time to print at the current layer height, if you don't care about the seam line printing at 0.2mm layer height is much faster. The vase has over 1 million triangles so may slow your slicer down a little. This vase was not designed to hold liquid. The original vase was made using Make My Vase from MakerWorld which I have modified by adding the texture. Powered by Make My Vase from MakerWorld (https://makerworld.com/makerlab/makeMyVase)