About this 3D model

This model was made to fullfill a need of blowing away sawdust from a workbench and leaves from a car. This was undoable with the standard long nozzle. The nozzle has a height of about 15 cm. The print takes about 2 hours and took 32 grams of filament on my P1S and fits directly. I printed it out of PLA+ with a=15% infill, if you're planning on leaving it out in the sun i'd advise you to print it from PET-G or ABS. This is a re-upload of my model because the old one was taken down for unkown reasons. The appeal failed too :(.