About this 3D model

Please note that the first print profile contains only the antenna cover, while the second print profile contains the VTX and GPS mount. Boost Me I designed this D-Rock V2 mount for the DJI Air Unit 03, striving for maximum protection while maintaining an acceptable weight and ensuring sufficient VTX cooling. Furthermore, it features housing for the RX and ExpressLRS antenna. For successful installation, you will need at least four M2 nuts and corresponding screws; the screws should be M2x1.6 and must not protrude. The antenna can be printed vertically with some base supports, while I recommend printing the GPS and VTX mount at a 45° angle with all supports enabled. To install the 03, first disconnect the antenna, route the cables through the designated housing, and reconnect. Then, insert the VTX into its housing and finally secure it between the standoffs. Before proceeding, however, ensure that the M2 nuts are recessed into their designated compartments. IF YOU DO NOT HAVE A 3D PRINTER, I CAN PRINT IT FOR YOU. CONTACT ME.