About this 3D model

Was making a “Brick” table for my son and though, 10$ a pop for plates? No way! So this is just a VERY simple version. It works very well using the .3mf provided for the X1c. If you do not wish to use the .3mf i recommend the following settings: Material : I just use PLA, PETG could be good, real “bricks” are made from ABS, I don't care for the smell so i'm sticking with PLA. 0.4mm nozzle 0.16mm optimal # BBL X1C Line width Default : 0.41 Outer Wall : 0.41 Top Surface : 0.41 Internal solid infill : 0.41 Top Surface pattern : Concentric Top shell layers : 3 Bottom surface pattern : Rectilinear Sparse infill density : 25 Sparse infill pattern : Gyroid As far as speed: Initial layer : 40 Initial layer infill : 95 Last but not least, bed adhesion Brim type : Outer brim only Brim width : 7mm Now you can play around with the infill, i went down to 5% which I used for my purpose (a glued on wood plate). I wouldn't recommend it for playable plates as it makes them too brittle and .. well lets face it, our “young ones” are not exactly delicate yet! Hope you guys like it. I plan on releasing another version that would be evenr better for glue adhesion.