About this 3D model

I was inspired by the LTT cable management arches (not yet released at the time, but featured on WAN Show ), and wanted to see if I could design a more flexible solution, both in terms of sizing and literary. You will need: 2x 15*3 Magnets per unit. That's the same size as for my other cable management solution . Some glue, preferably the kind that dries very quickly. Printing: I tested up to a 0.3mm layer height and a 0.6 nozzle and it worked perfectly, no need to go with a smaller layer height. PLA is recommended to minimize warping and lifting of the corners - there are a lot of small parts here that the nozzle could easily knock loose. Z-hop should be on for the same reason. Make sure the bed is clean (same reason). If the nozzle is still knocking stuff off the bed — slow down the print to 75–50%. Post-Printing Remove the model from the build plate. Put a drop of glue in both magnet holes. Don't use too much glue , or it will splash out or glue your finger to the magnet. Insert the magnets into the holes in the same orientation . This will let you turn the cable holder into a ring what attaches with double strength at a single point. Wait for the glue to dry, then enjoy. Want a Different Size? Scroll down to the bottom of the files list and download the .f3d source file for the model.