About this 3D model

Please keep all these small parts away from children and pets, some parts have pointy ends, and they could be a choking hazard too. Make or use these models at your own risk. I liked OpenSourceClassroom's "Magnet Hardware Helper" ( https://www.thingiverse.com/thing:1277529 ), but wanted something simpler and smaller that would fit in my Stanley organizer where I keep my metric hardware ( https://www.prusaprinters.org/prints/79702-stanley-014725r-organizer-bin-dividers-with-step-f ). This was pretty simple to design in about 5 minutes and it printed in 21 (went with 3 walls and 15% gyroid infill in PETG). I suggest using a brim as well. It works great and I did not need any glue (the ID of the bore is 5.4mm so it will be snug). If it's a bit loose however, you can add a drop of superglue to the end, to help keep it it place. I used a 5x15mm neodymium cylinder magnet but a 5x10mm cylinder magnet may also work. The magnet goes into the tool about 5mm. No supports are needed for this model. If you find these models useful, please post a like or a comment with some pics of your prints. Boost Me Thanks for supporting my work! You can find the other things I'm working on at my blog here . You can also follow me here or on Printables, to see what new stuff I post. If you would like to support my work, you can Buy Me A Coffee using this link: https://www.buymeacoffee.com/mystoopidstuff