About this 3D model

Summary This is a device to extend the legs of a Siglent oscilloscope. I made it for a SDS1202X-E but I assume it would fit their other model. Post a comment if you find it fitting other pieces of equipment (although I still can't see people's comments). I found, that using the scope on my bench, it was difficult to read the top of the screen and I needed to tilt it back more. I started propping up the front legs so I built this prop. It has 3 positions that lift the front up about 2", 2.1, and 2.3 increasing the tilt. Printed mine with 20% fill using PLA. No support needed.