About this 3D model

ORIGINAL BY 3DVINO https://makerworld.com/en/u/1641491843 Hi! This is a very simple remix of the original model. Its a poop chute that goes from the printer to the top drawer. To keep it in place, I have used a magnet which has a diameter of 10mm. The model is very discreet which made me want to make a remix that suited me. The first model was for another bureau so I had to make some adjustments. It is made of two pieces. I still use the same bottom but the top part is made completely from scratch. It's quite tight fit but the models stick well to each other. I have a granite/stone slab under my printer that is 3cm high. Keep that in mind cause it maybe wont fit if you dont have it raised like me. It may fit other setups as well so feel free to try it out. I use a p1s but should work for the X1 series to.