About this 3D model

In the profile, the yellow is set with BambuLab PLA but I've used the below-mentioned Eryone one. Overall shouldn't be a mentionable difference between the two, just keep in mind. Printing Instructions: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.28mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Matte Scarlet Red Transmission Distance: 2 PLA Eryone HyperSpeed Yellow Transmission Distance: 14 PLA BambuLab Matte Ivory White Transmission Distance: 4 Swap Instructions: Start with Black At layer #6 (0.68mm) swap to Scarlet Red At layer #12 (1.16mm) swap to Yellow At layer #19 (1.72mm) swap to Ivory White for the rest. If you are satisfied with my design, I would be delighted if you could support me!