About this 3D model

This is a remix of PeakPoke's riser which is an awesome print and I really appreciate you sharing! A few tweaks I made - for me the glass wasn't fitting correctly so I opened up the width and length to accomodate - I added channeling for the LED wiring under the frame - I added a slot holder for a Adafruit QT PY Pico Board that I use to control WLED - Added a small notch on the backside to hold a 10mm magnet The print in general fit together but needed a bit of sanding here and there. I only used Bambu filament so if you use other filament print at your own risk. Otherwise, hope you enjoy!