About this 3D model

A Dust Cover for the A1 Hotbed, solving a small problem of dust accumulation on the hotbed. If you find any imperfections, feel free to contribute to its improvement! Note: After printing, allow the hotbed to cool down to room temperature before removing the model to avoid part deformation. 1. To achieve the design goal of full hotbed coverage and glue-free assembly, two versions of the model need to be printed. 2. Before assembling, use a craft knife to trim away the 1mm thick supports (as shown in Figure 1) （图1） 3. After removing the skirt, slide the two pieces together (as shown in Figure 2), and then assemble them from one side (as shown in Figure 3) （图2） （图3）