About this 3D model

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm It is possible to print this even without AMS, just use the pause command at the layer described, and replace the color of the filament with the one in the description!! And it is possible to change the secondary color with one of your liking, I used yellow, but just replace this color to have the desired color effect, leave the colors black, gray and white! Swap Instructions: Start with Black At layer #6 (0.56mm) swap to Yellow At layer #12 (1.04mm) swap to Gray At layer #19 (1.6mm) swap to White for the rest. Good print!