About this 3D model

This model has only been tested on a BambuLab X1C and A1, using PLA. Expect different results if using different machines or materials. If printing on a Textured PEI plate, a brim is strongly recommended on all parts. I do not recommend using Silk PLA on this model, as it was brittle on the smaller links on my full-colour test. Use silk PLA at your own discrepancies. HOWEVER; the single-colour was printed using Gratkit duo-tone Silk PLA, and the tailtip was fine. This articulated Arbok has 36 joints, though at the scale I have provided there is plenty of room for more links, should you want to add them! All body links, except the one closest to the tail tip, are identical so you can copy/paste them to make the body longer. The size I have provided is the largest I could make the full-colour version before printing time became too long. Be aware that bleeding can occur if your filament has additional qualities to it (such as sparkle glitter). Brims and supports are not required on the entire model, but is recommended on the “head” segment, as the part is tall. The only exception is if you use a textured PEI plate, whereby a brim is needed on all segments. Raw STL files are Patreon exclusives. If you want access to them, or to sell prints of this model, please consider subscribing to my Patreon: https://www.patreon.com/thomastedwards