About this 3D model

Tips when you use the seal: - Pour hot wax directly onto the face of the seal to get into the deep sections; fill the cat's head. Then pour a good amount onto the paper. Place the seal onto the paper. - Leave to cool for about 2 minutes, then pull the seal away. - For best results, pre-pour your seals on aluminum foil, let cool, then peel them off and "spot-weld" the finished seal onto your letter with a small dab of melted wax. This seal is sized by default at a large 25 mm in diameter. A medium seal should probably be about 22 mm and a smaller seal, 20 mm. There is an arrow cut into the back of the seal so you can orient it onto the paper properly. See printing details for information on supports. I hope you and your pen pals enjoy it!