About this 3D model

For my specific needs, I required a headphone/headset hanger that could be easily mounted on a variety of shelf or tabletop thicknesses. Additionally, I preferred a hanger with the capacity to hold two headphones. This hanger is designed to fit tabletop thicknesses ranging from 1.5 cm (using the longer screw) to 5.5 cm (utilizing the shorter screw). It features two arms to accommodate wider headbands, with the shorter arm measuring 110 mm and the longer one measuring 140 mm. The one in the photo is the shorter one. Note: The file contains 2 screws and 2 arms. You only need one screw and one arm. Choose based on your needs. Initially, the screw might be quite tight. After a couple of uses, it should loosen up a little. I highly recommend the use of anti-slip pads to enhance friction and stability. It's important to exercise caution with heavier items, as the design has only been tested with headphones of "typical" weight. Please feel free to reach out if you have any feedback or suggestions for minor tweaks. Thanks!