About this 3D model

Membership Sign up to my "3D Print Vendor" membership to sell prints of my models. Signing up is a huge support for me and I appreciate you greatly Patreon - https://patreon.com/CosmicNimbusPrinting Cults3D - https://cults3d.com/en/users/CosmicNimbus UPDATE 01-07-25 I've dialed in settings with Bambu Lab's TPU HF filament and have my first shoe printed really nicely ! I've been experimenting with different settings, orientations, and altered the model slightly as well. - Changed orientation in print profile to print on the toe, so the bridge prints nicer - I removed the heal from open version, as it printed well without it - The print only worked for me if I print it quite slowly - these settings are in the new profile - Added v3 shoe models, which are superior - I printed this shoe at 94.7%, which is a woman US 8.5 for my partner - Will update sizing chart once I have a full set printed NOTE: This is printed with TPU supports, which come off relatively easily. For best results, I reckon it's worth printing this with PLA or dissolvable supports if possible with option “support critical regions only” turned off, and “Threshold angle” set to 30. I had a few bad experiences printing with lots of supports as they are hard to remove when printed in TPU and there are a lot of them, so I changed these 2 settings. Paradoxically, I think the finish will be even nicer in some areas that sag if printed with dissolvable supports, but this hasn't been tested UPDATE 15-06-25: There has been quite a bit of attention on these shoes, which was originally a design exercise for me! I have finally been able to put the time into working on them again with a lot of new skills since I made them. I've listed below the updates I have made. I'm excited to see people's prints of these ! I've test printed the left open version in PLA, but am doing maintenance on my printer atm. When it is working again, I will print them all in TPU. The size of the crocs are supposedly UK40, but They fit me snuggly and I am a US9.5 normally. I'm not sure how accurate the size guide is, I will be updating this when I get them all printed - Altered the crocs model so there is more space around the toes to fit the feet - Added a second variation of the shoe that keeps the pattern, but have enclosed walls - Finally added a print profile ! - I've also added 2 orientations, one up on it's heal, and a version that is completely flat without the cut in the heal 18 May 24 EDIT: I've added an estimated size guide based off MakerVerse Designs 's crocs. I also added a heal to the model and angled it up like their crocs so it's easier to print. You may need some basic support pillars still, like they describe in their listing. A voronoi remix of Jjhu's crocs - size 40, US 7.5 men, US 9 women Hi there ! I challenged myself to learn how to make Voronoi models. To make the model I remeshed the model first with “Instant Meshes” to go low poly, then used a couple modifiers in blender to turn it Voronoi. I have this model on Printables, but thought I'd share it with the community here as well. I haven't printed these myself, but someone who had success and did print it commented that they “printed with 2 wall loops, 10% gyroid infill, manual tree supports, and at a 45° angle to prevent too many overhangs.” They use TPU to print them Tbh this was more of a design and rendering exercise for me but I wanted to share it anyway ! The original model was sized as 40, US 7.5 men, US 9 women. Surely you could scale these to make them different sizes, but I would do some measurements in the model before printing to make sure they're the desired size. Happy Printing !