About this 3D model

Boost Me Boosting is the best encouragement for designers, or a five-star rating is also excellent motivational support December 19 Added extreme angle printing test If even 45 degrees cannot be printed well, this is serious, please check the filament parameters or bake the filament before printing again It is normal for the PLUS version to print poorly, please do not give a rating lower than five stars August 14 Added 1CM assembly tolerance test cube Usually printing 0.1~0.3 is sufficient for testing After printing, combine it through the X-Y-Z directions, and determine the tolerance value during design based on the tightness Test cube for new machines