About this 3D model

Hello World! These are my Picture / Poster Frame Holders for extra support if the included frame hangers aren't good enough for what you want to do. They snugly fit the edges of a 1x1 frame. I designed it to help hold the frame together even on the most difficult angles. This is my first project and I think it turned out very well as they have been holding my big posters on a steeply angled vaulted ceiling with no problems for several months now. How they work is the screws pass through the hole and then slide into the channel while the poster simultaneously slides into the brackets until you feel it stop. First, you have to measure and lay out where the screws need to be for your poster. To do this dry fit everything and then place the poster on the wall and trace around it. Then put in the screws and tighten them up to where you can barely take the bracket off and on. With all 4 hangers on snugly, the combined friction will keep the poster from ever accidentally falling. The top brackets go on first then you can get the bottom brackets on and slid into place as someone is holding the frame from falling. I would recommend having one or more people help you as it's challenging. I want to give this to the community in hopes that it will allow me to get a new Bambu 3D Printer as I have the Ender 3 right now. If you have any questions I can try to help! Thanks and I hope you enjoy <3