About this 3D model

Flow Clip "Leave on" Filament Clip Design #7 Flow Clip. I wanted a filament clip that I could leave attached to the spool when in use. It had to allow the spool to spin freely inside the AMS system, and it couldn't interfere with the AMS feeder. Enjoy! Details: Clip can be left attached to the filament when in use. Works with the AMS system, and likely any spool holder as well Falls off inside the AMS bay when filament runs out. Pick it up and slap it on the next roll Does not interfere when stacking filament Uses less than 2grams of filament let me know how it works out for you. I've ran this setup for a little while with no issues, but your miles may vary. If you like this design, maybe check out a couple of my others below ? https://makerworld.com/en/models/238354#profileId-254240 https://makerworld.com/en/models/220617#profileId-239114