About this 3D model

This is my rough version of a vortex cooler. When putting compressed air into the inlet tube cold air will exit from one end and hot air will exit from the other. This takes a lot of air. You will probably need at least a 5 gallon air compressor as this requires a large amount of flow at about 90 psi air. With 90psi air the cold exhaust will be about 25 degrees cooler than the input air and the hot side will be about 15 degrees warmer. The temperatures can be adjusted a little by pushing the hot end cap in or pulling it out slightly. Here is a sciencey explanation: http://en.wikipedia.org/wiki/Vortex_tube If anyone knows more about how to improve this design I welcome your comments. I made this with no science involved with the design and was happy to have pretty good results.