About this 3D model

This model uses a clamp mechanism to hook itself onto a table to support the weight of a pair of headphones. Print Specifications: Infill: 20% Cubic/Grid infill pattern 0.2mm layers Slicing Instructions: Dilate small screw by: X-Axis: 160% Y-Axis: 160% Z-Axis: 200% Print 2 small screws Dilate big screw by: X-Axis: 360% Y-Axis: 360% Z-Axis: 400% Print each part on it's side, no supports will be required Assembly Instructions: Place the clamp on a desk Screw in the clamp to the desk with the big screw until you feel slight resistance (screwing in too tightly might result in breakage of part) Lineup the 2 screw holes on the headphone stand with the 2 screw holes on the clamp Screw in the clamp and headphone stand with the 2 small screws Helpful video: