About this 3D model

"Memories" If you like to scale, do it only with x and y axis, do not change z axis! Print at 100% infill with a layer height of 0.08mm and a base layer of 0.16mm Wallgenerator is set to “ Arachne ” for better results, if your CPU is slow, change it to " Classic " For better results you can use a 0.2mm noozle, just leave all other settings as they are. Filaments Used: PETG BambuLab Basic Black Transmission Distance: 0.3 PETG BambuLab Basic Red Transmission Distance: 2.5 PETG BambuLab Basic Yellow Transmission Distance: 6.0 PETG BambuLab Basic Nature Transmission Distance: 8.0 Swap Instructions: if you don't have ams just put pause on specified layers and swap filament manually Start with Black At layer #12 (1.04mm) swap to Red At layer #15 (1.28mm) swap to Yellow At layer #18 (1.52mm) swap to Nature for the rest. If you wanna use PLA: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Tough Vermillion Red Transmission Distance: 3.0 PLA BambuLab Basic Yellow Transmission Distance: 6.0 PLA BambuLab Basic Beige Transmission Distance: 8.0 Just leave all other settings as they are. I wish you always a clean nozzle!