About this 3D model

Hi, I would like to introduce you to my New Phone Stand Exagon V2 This is a rivisited version of the first model that has been highly appreciated by users. I hope you like it. Good Print ! If you have any problems with adhesion you can try turning off aux fan when printing PLA You can find the first version here https://makerworld.com/en/models/193049#profileId-214820 You can find the raised version (allow charging) here https://makerworld.com/en/models/397838#profileId-299273 If you like my project consider supporting my job with a boost. Thank you ! Attention A1 series : In some cases only on the A1 series someone has reported problems. I tried various prints on my A1 mini without problems, like other users, but someone has reported problems. I don't understand what the problem could be generated (firmware? slicer? bed slinger? air flows?) I don't think it's a profile problem but I can suggest if you want to try to use a standard profile 0.2