About this 3D model

Give your Bambu printer a BROFIST - A direct replacement for the stock Bambu carbon filter in the X1C/P1S. It can also function as an added filter at the bottom to the sides (out of the way of the bed). A bit of tape between the lid & box, then doubled over on the outside will serve as a pull tab. Or you can use tweezers. The world is your oyster! Save money by buying your carbon filtration material in bulk. ----------------------------- To install in a vertical orientation at the bottom of the chamber (not required, but a nice option, you will need: 4x M3 Short heat inserts from CNC Kitchen 4 x M3x4mm TX10 bolts from CNC Kitchen (4 x M3x4mm Hex machine bolts should work, provided the heads are not deeper than 4mm total) Heat insert tip to suit. ----------------------------- Sliced and printed as pictured in the 0.20 Strength preset using eSun Black ASA with some minor changes: Seam position - Back 4 Walls 4 Top & Bottom Shells Top, Bottom and Solid Infill pattern - Rectilinear. 35% Adaptive Cubic infill Enable Supports - Tree (auto) Supports on build plate only Support critical regions only 1 Top Interface Layer ----------------------------- 3mf file is set to my own filaments, using Polymaker Army Green ASA for support/raft base and Polymaker Orange ASA for the interface layer. Works fine as shown. Adjust accordingly to your setup.