About this 3D model

The Rainforest Bromeliad Display is the perfect spot to display multiple Amazonian animals or just tons of dart frogs (Not included)! This file comes in two parts, a top and a bottom. Both are print in place (Make sure to slow down for overhangs on the top plant part). I printed it at full size and also 54%. No glue is needed to connect the two parts: the top is loose enough to slide into the bottom part, and even spin if you like! The bottom part is not structurally required, and can be skipped. The top file I printed multicolor with layer changes.3D printing settingsPrint Settings: All files are No supports needed Print in Place 2-3 walls 5-10% infill For the top file of the rainforest display, make sure your slicer slows down for overhangs, the leaves bridge together on the first part of the Bromeliad plant. Rainforest Bromeliad Display Bases: Bambu brown Bromeliad top (layer changes): Bambu basic green, bambu matte scarlet and ice blue, Elegoo yellow, Overture matte light brown. All files were printed and tested on Bambulabs printers: P1P with AMS and an A1 mini For commercial use and/or more information, please check out my Patreon or MMF Tribes and the post associated with the files. My post releases will always be public (you do not need to be part of my Patreon or MMF to see the post), and there are more pictures available, and possibly more information and tips! MMF was Started in September, so Patreon will be necessary to look at older posts. If you would like to see a list of what flexis are included in the Welcome Folder: Please click Here Patreon MMF Tribes