About this 3D model

A fun little remix of mars730's adorable little gingerbread house, to add variety to your tiny village! I designed mine for two color changes, and print at 0.2mm layer height. I found that if you print it on a Cool plate with a glue stick, the best way to remove it is with a palette knife where you carefully go around the whole model and push gently under it with the palette knife edge. Make sure to use a pair of scissors or some an Xacto knife to remove the connecting tabs so that everything will line up ok. I've included both the stl files and two 3mf files, one for single color, one for two colors. I hope you enjoy it, and thanks again to mars730's original design! I would love to see any and all prints! :)