About this 3D model

3D model descriptionCompletely print in place with colored models included - cute fun and highly flexible with 2 versions available.3D printing settingsFully print in place with no support or brim needed so long as you have good bed adhesion. I kept the wall thickness at 0.42mm with 2 walls. Speed was 200mm for the walls. Gyroid infill recommended at 15%. If printing in silk I recommend it increase the model size by at least 50 percent with a minimum of 3 wall, 25% infill, slower printing speeds and a higher nozzle temperature. (highly dependant on the silk used)